IP Surveillance Setting 
DVRs Setting 
FAQ 


   
 
DVR Setting l Support
 
Untitled Document
 
1. How to set up Windows
2. How to set up Firewall
3. VGA
4. List of programs to be installed
5. How to update programs
6. How to save existing settings when
updating programs

7. How to set up recording disc
8. How to change user ID and password
9. How to adjust the speed of recording
10. How to set up motion recording
11. How to set up sensor recording
12. How to set up De-interlace

13. How to control PTZ
14. Controllable PTZ

15. How to set up e-mail

16. How to set up Anti-Pirating function for pictures
17. How to check if image data have been pirated
18. How to set up audio
19. How to set up sensor/alarm
20. How to back up data
21. How to connect DVR to Client program
22. How to set up an alarm for DVR in Client
23. How to connect DVR to IE(Internet Elplorer)
24. How to utilize DDNS service
25. How to set up IP(or Router)
 

10. How to set up motion recording

[Designation of range of motion]
To set up motion recording, a range of motion should be designated.
DVR program –> environment set-up –> camera/motion –> designate a range of recording.
The square block on the camera picture window indicates the designated range.



[How to adjust sensitivity to motion]
The sensitivity to motion can be adjusted by ‘Sensitivity control’ shown at the right middle of the figure below. Move the bar from right to left and back. When you get a setting value, save it.

[How to check sensitivity]
Select ‘Motion range output’ in the ‘Motion detecting event block’ and the camera reacts to motion and a blue-colored block appears the camera picture window at the left.

[How to set up the schedule of motion recording ]

DVR program –> environment set-up –> schedule –> select day by weekdays/weekends